Category:WindPRO 3.4 Service Pack 2

Below you will find a list of all issues fixed in Service Pack 2:

This Service Pack contains corrections to bugs reported by users. Thanks to all for submitting feedback.

BASIS

• Fixed issue where noise data would be labeled as source "USER" instead of "EMD"
• Fixed issue where georeferencing a map could cause an exception
• Fixed issue where roads would not connect
• Fixed annoyance where loading PowerMatrix files containing unsupported data would generate a lot of error messages

DECIBEL

• Fixed error in reflection distance calculation where the reflected distance would be overcompensated. Calculations using reflections made between windPRO version 3.4.404 and 3.4.414 should be recalculated.
• Fixed issue in the manual check of automatically calculated noise values, where octave values could be falsely stated as available and "Start calculation" would be greyed out
• Fixed issue in the manual check of automatically calculated noise value with redundant input

LOAD RESPONSE

• Fixed issue where using an ed. 3 response model in ed.4 calculation would force the normalization loads to be locked to "using response model" (as for the generic)

METEO

• Fixed issue where out-of-range data could be enabled from the "Data" | "Time series" tab
• Fixed issue where a flag would not be displayed and it was not possible to jump to the next flag
• Fixed issue where the rose view plot would hide signals when then number of sectors was increased

METEO ANALYZER

• Improved time it takes to swap the axes of two large datasets in XY graph
• Fixed annoyance in Weibull graph where line colors would be slightly different to the legend
• Fixed issue in Wiebull graph where the list of sectors would sometimes be limited to "All" when selecing heights with a different number of sectors.

ONLINE DATA

• Cancelling a climate data download no longer gives an error message

PARK

• Fixed an error in the Time-varying N.O Jensen wake model. In our test-projects the relative differences in AEP going from 3.4 to 3.4 SP2 is typically ± 0.05%, but may be up to -0.52%. This is ONLY in org. N.O Jensen (PARK1) model and only by time varying calculations made in windPRO version 3.4 and 3.4 SP1.
• Fixed issue where it was possible to select both "WakeBlaster request" and "WakeBlaster calculation" simultaneously
• Improved message when scaler height is below displacement height

PERFORMANCE CHECK

• Fixed issue where setting the filter for "minimum number of WTGs operating simultaneous " would hide error codes in time series graph
• Main statistics for error codes simplified, by removing mean and standard deviation to improve loading speeds
• Fixed error where running an external PARK calculation from within Performance Check could cause loss of data

PHOTOMONTAGE

• Fixed error where Solar PV panels would be cut off if the Camera object was close to a very large Solar PV area

SHADOW

• Added hidden possibility to display extra decimals in shadow results. Contact support@emd.dk for more information

SITE COMPLIANCE

• Fixed issue with Seismic data in Site Compliance. In certain projects the location of the Seismic map would be wrong
• Fixed issue where deleting the last remaining Shear value and adding a new one would throw an exception
• Fixed annoyance where turbulence graph would not be fully painted (although visible)
• Fixed issue where removing calculations for air density, wind shear, flow inclination and effective turbulence could cause an exception

Technical issue

• Fixed issue where cancelling a IEC 61400-12-1 Angle & Terran check calculation would later create an empty report in the calculation list

WAsP CFD

• Fixed issue where "Site Data Object - Purpose: CFD" would not display the map of the calculation area, when using geographical coordinate systems.