Category:WindPRO 4.0 Service Pack 4: Difference between revisions

August 2024, build 4.0.552

Below you will find a list of all issues fixed in Service Pack 4

This Service Pack contains corrections to bugs and comments reported by users. Thanks to all for submitting feedback.

See list of previous releases here: windPRO releases

The items below are ordered alphabetically by module, then by importance.

BASIS

• Fixed issue where adding holes to e.g. Corine data would cause the Displacement Height Calculator to use the same height for all directions.

METEO

• Improved detection of time stamp format in AQ data files.

LOSS & UNCERTAINTY

• Fixed issue where it was not possible to generate a report if the noise loss report was activated.

PARK

• Fixed an error in the Ainslie 1988 wake model in special situations. It is recommended to do a recalculation if you have used the Ainslie 1988 wake model on a site with a densely packed neighboring windfarm with a low hub height located more than 100 rotor diameters upstream of a sparsely packed, much taller wind farm. A recalculation will yield lower wake losses in general.
• Fixed error with f-parameter of RSF files not being properly normalized when using several Meteo objects for calibration.
• Fixed error in the IEC power curve correction for power curves experiencing ramp-down after rated power where the ramp-down values would be corrected when they should have remained uncorrected.

PERFORMANCE CHECK

• Fixed issue where copy to clipboard did not work in the Wind speed substitution tab.

PHOTOMONTAGE

• Correction of WTG information when sorting after User Label in the report.

SITE COMPLIANCE

• Fixed error in weighting of extreme ambient turbulence when using a wind statistic with 36 sectors together with WEng using 12 sectors.