Difference between revisions of "Category:WindPRO 3.4 Service Pack 2"

Below you will find a list of all issues fixed in Service Pack 2:

This Service Pack contains corrections to bugs reported by users. Thanks to all for submitting feedback.

BASIS

• Fixed issue where noise data would be labeled as source "USER" instead of "EMD" Link to TD in Story Manager
• Fixed issue where georeferencing a map could cause an exception Link to TD in Story Manager
• Fixed issue where roads would not connect Link to TD in Story Manager
• Fixed annoyance where loading PowerMatrix files containing unsupported data would generate a lot of error messages Link to TD in Story Manager

DECIBEL

• Fixed issue in the manual check of automatically calculated noise values, where octave values could be falsely stated as available and "Start calculation" would be greyed out Link to TD in Story Manager
• Fixed issue in the manual check of automatically calculated noise value with redundant input Link to TD in Story Manager

METEO

• Fixed issue where out-of-range data could be enabled from the "Data" | "Time series" tab Link to TD in Story Manager
• Fixed issue where a flag would not be displayed and it was not possible to jump to the next flag Link to TD in Story Manager
• Fixed issue where the rose view plot would hide signals when then number of sectors was increased Link to TD in Story Manager

METEO ANALYZER

• Improved time it takes to swap the axes of two large datasets in XY graph Link to TD in Story Manager
• Fixed annoyance in Weibull graph where line colors would be slightly different to the legend Link to TD in Story Manager
• Fixed issue in Wiebull graph where the list of sectors would sometimes be limited to "All" when selecing heights with a different number of sectors. Link to TD in Story Manager

ONLINE DATA

• Cancelling a climate data download no longer gives an error message Link to TD in Story Manager

PARK

• TBD Link to TD in Story Manager
• Fixed issue where it was possible to select both "WakeBlaster request" and "WakeBlaster calculation" simultaneously Link to TD in Story Manager
• Improved message when scaler hieght is below displacement height Link to TD in Story Manager

PERFORMANCE CHECK

• Fixed issue where setting the filter for "minimum number of WTGs operating simultaneous " would hide error codes in time series graph Link to TD in Story Manager
• HSP? Link to TD in Story Manager
• Fixed error where running an external PARK calculation from within Performance Check could cause loss of data Link to TD in Story Manager

PHOTOMONTAGE

• Fixed error where Solar PV panels would be cut off if the Camera object was close to a very large Solar PV area Link to TD in Story Manager

SHADOW

• Added hidden possiblility to display extra decimals in shadow results. Contact support@emd.dk for more information Link to TD in Story Manager

SITE COMPLIANCE

• LS? Link to TD in Story Manager
• Fixed issue where deleting the last remaining Shear value and adding a new one would throw an exception Link to TD in Story Manager
• Fixed annoyance where turbulence graph would not be fully painted (although visible) Link to TD in Story Manager
• Fixed issue where removing calculations for air density, wind shear, flow inclination and effective turbulence could cause an exception Link to TD in Story Manager

LOAD RESPONSE

• Fixed issue where using an ed. 3 response model in ed.4 calculation would force the normalization loads to be locked to "using response model" (as for the generic) Link to TD in Story Manager

Technical issue

• Fixed issue where cancelling a IEC 61400-12-1 Angle & Terran check calculation would later create an empty report in the calculation list Link to TD in Story Manager

Wasp CFD

• TBD Link to TD in Story Manager