Schwedische Vorschrift 2009 (Englisch): Difference between revisions
No edit summary |
No edit summary |
||
| Line 37: | Line 37: | ||
'''Curtailment optimization considerations''' | '''Curtailment optimization considerations''' | ||
The Swedish 2009 only allows optimization on the time domain. | The Swedish 2009 only allows optimization on the time domain. | ||
Latest revision as of 16:55, 21 June 2024
Zur deutschen Hauptseite | Alle deutschsprachigen Seiten
The Swedish codes 2009 actually represent an evolution of “Ljud från vindkraftverk”, Naturvårdsverket. The latest available version is from April 2010, but the latest modifications are at the time of writing only available from Naturvårdsverkets homepage Mätning och beräkning av ljud från vindkraft (naturvardsverket.se)
This latest version, for ease called Swedish 2009 as the 2009 edition provided some of the most important changes, is generally based on the original “Ljud från vindkraftverk” with the following modifications:
- a. Roughness correction of source noise level has been removed and replaced by the standard 0,05 m wind profile
- b. Revised code for offshore calculations
- c. Option of comparing with ambient noise (masking)
- d. Allowing for Nord2000 calculations
Naturvärdsverket has published a guideline Vägledning om buller från vindkraftverk describing thresholds, selection of propagation models and procedures concerning verification.
Roughness correction
The elimination of the roughness correction greatly simplifies the calculation. Instead of modifying the wind speed at hub height based on a roughness specific wind profile, all calculations now assume a standard IEC profile of 0,05 m, which is used by basically all other national codes. This means that the noise figure in the wind turbine catalogue of windPRO can be used directly without modification. Therefore the selection of roughness length has been removed. This affects both onshore and offshore calculations.
Wind speed
The source noise wind speed is selected as the one giving the highest noise level. In earlier versions of WindPRO this code used 8 m/s at 10 m height. If you are trying to reproduce earlier calculations this option can be checked.
.png)
Offshore calculation
The offshore calculation calculates similar to an onshore calculation out to 1000m from the turbine. From then a revised version of the 2002 code with different dampings are used. The noise is calculated at landfall and from then uses the land code to the dwellings. The formula in the current form is at the time of writing only available from here: Mätning och beräkning av ljud från vindkraft (naturvardsverket.se)
In windPRO DECIBEL select Swedish 2009 and select Offshore wind farm. If that option is checked, click the button Edit water areas to select an area object defining the sea. Any purpose of the area object will do. Any location outside the selected area type is considered on land and the boundary of the area marks the coastline.
Curtailment optimization considerations
The Swedish 2009 only allows optimization on the time domain.
NORD2000
From 2009 the Swedish code allows the use of NORD2000 as an alternative method. NORD2000 is not part of the DECIBEL module, but a module on its own.
Swedish Low frequency noise
The Swedish guideline for low frequency noise as it is described by Naturvårdsverket cannot be calculated with DECIBEL. Instead NORD2000 in windPRO can be used to calculate low frequency noise.